- Same day quote from your photos
- In-house every wire run by our own electricians
- 400+★ five-star reviews across Texas
- Certified for Tesla & every major brand
How this works
Five steps. The second one is the only part we need from you.
-
Tell us about your project
The form takes about two minutes. Service type, your details, and the address so we can look up your panel location and likely wire run.
-
Send us three photos
This is the step that decides how fast you get priced. We send you a link right after you submit, and it tells you exactly which three — your panel, the wall where the charger goes, and the path between them. Two minutes, standing in your garage. No measuring.
-
Get your quote
Once we can see your setup, we price it the same day. No site visit, no four-hour window, no salesperson in your living room.
-
We handle the permit
City of Austin, Travis and Williamson County, Round Rock, Cedar Park, Pflugerville — we pull it, we schedule the inspection, we deal with your jurisdiction. You don’t file anything.
-
Our electricians install it
Our own crew, never subcontracted. Most installs run a few hours, and the exact time depends on how tricky the run is — we’ll tell you what to expect when we quote. We clean up before we leave.
PRICING
What an Austin install actually costs
Almost all of it is distance — every foot between your panel and where you park is wire, conduit and labor.
Panel in the garage, charger on a nearby wall.
Across the garage, through an attic, or around a corner.
Detached garage, a second-story run, or a trench.
Disclaimer: These prices are based on the average install and do not include the cost for the charger, permits, additional panel upgrades or load management devices. They also assume your existing panel has the space and capacity to carry the continuous load of a Level 2 charger. Prices may vary depending on the complexity of the install.
Questions people ask before they book
If yours isn’t here, put it in the form or email us at info@chargeprotexas.com. We’d rather answer it now than have you find out halfway through.
Before you book
Why can’t you just tell me a price over the phone?
Because the honest answer depends on things we can’t hear. Two houses on the same street can be $800 and $2,100 apart if one has the panel in the garage and the other has it on the far side of the house behind a finished wall. Anyone who quotes a flat number sight-unseen is either padding it or planning to revise it on install day. A few photos take two minutes and get you a number we’ll stand behind.
How fast can I get a quote?
Same day, once we have photos. The clock doesn’t really start when you submit the form — it starts when we can see your panel and where the charger goes. Send them right after you submit and you’ll usually hear back within hours.
I need this done quickly. Can you do that?
Tell us it’s urgent and we’ll try to find a gap in the schedule for you. We don’t promise a date we can’t hold, but we’d rather work at it than let you assume the answer is no.
The part that’s genuinely fast is everything before the install. Once we have your photos, the quote goes out the same day — and once you accept it, it’s purely a scheduling question. The permit and inspection run alongside that.
Do I need to be home for the install?
Not necessarily you, but someone has to let us in. Depending on the run we may need access to the garage, the panel, the attic, and sometimes the back yard — so whoever’s there should be able to open all of it.
The inspector needs access too, on a separate visit. We’ll coordinate both with you.
Do I need a permit?
Yes. A Level 2 charger means a new 240-volt circuit, and that requires an electrical permit in Austin and every surrounding jurisdiction.
We pull it, we schedule the inspection, and we meet the inspector. And we guarantee it passes — if the inspector flags anything, we come back and put it right at our cost. You don’t get a second bill and you don’t get left chasing it.
Do you need to come out before quoting?
Most of the time, no — photos are enough, and quoting from them is free. That’s how you get a number today instead of an appointment in two weeks.
Some houses are genuinely complicated, and for those we’ll either come back to you with more questions or ask to walk the job in person. A site visit is $250, credited back against your install if you go ahead with us. We’ll tell you if we think you need one rather than quoting a guess.
What’s covered if something goes wrong?
A one-year workmanship warranty, with extended coverage available. Your charger carries its own manufacturer warranty on top of that, usually around four years. And because our own crews do the work instead of a subcontractor, the person who answers your call is the person responsible for the install.
Is there a rebate or tax credit?
Austin Energy offers a rebate on home EV chargers, and the program is changing as of October 2026. Under the new terms, Austin Energy customers can get half the charger’s price back, up to $500, if their charger or their car can enroll in Austin Energy’s Power Partner EV program. That includes most Teslas and recent GM EVs. The rebate covers the charger, not the installation. Terms can change, so check Austin Energy’s rebate page for the current details, and we’re happy to help you work out whether you qualify.
The federal 30C tax credit for home charging equipment expired June 30, 2026, so that one is no longer available.
The technical stuff
Hardwired charger, or a NEMA 14-50 outlet?
Hardwired, almost always. It’s safer, it lets you charge faster, and if you move we can take it off the wall and reinstall it at the new house without much trouble.
The outlet sounds cheaper and usually isn’t. It needs an extra conductor run to it, and it needs a GFCI breaker — those are expensive, and they nuisance-trip often enough that you’ll notice. You also cap out at 40 amps. There are situations where an outlet is the right call and we’ll say so, but it isn’t our default.
How many amps should I get?
48 amps wherever your panel allows it. It’s the fastest you can charge at home, it fills the car comfortably overnight, and asking for less won’t save you money — we run 6 AWG wire on every charging circuit as standard, so the copper going in your wall is the same either way. That also means if you upgrade the car or the charger later, the wire is already there.
We only go smaller when the electrical service genuinely can’t carry 48 amps — and if that’s your situation, a load management device often gets you there anyway without a full panel upgrade. We’ll tell you which one your house needs.
What’s a load calculation, and do I need one?
It’s the math that confirms your electrical service can carry a charger on top of everything else in the house. A charger is a continuous load, which is why a 48-amp charger needs a 60-amp breaker — the circuit gets sized at 125% of the load.
We run the calculation free on any panel that looks tight or dated. If the numbers don’t leave room, the answer is usually a load management device rather than a service upgrade — a few hundred dollars instead of a few thousand. Either way you’ll see it itemized before you commit.
What if my panel is old, or a brand I’ve heard is bad?
Worth asking about. Federal Pacific Stab-Lok and Zinsco panels have a documented history of breakers that don’t trip when they should, and we won’t add a 240-volt circuit to one — not to upsell you, but because we’d be attaching a continuous load to equipment that can’t be relied on to protect it.
If that’s what you have, we’ll tell you, show you the label in your own photos, and price the replacement honestly. Anyone who quotes a charger on a Stab-Lok without mentioning it either didn’t look or didn’t care.
My panel is outside and the car parks in the garage
Extremely common in Austin, and a big part of why we quote from photos. The run might go through the attic, around the exterior and back in, or straight through the wall behind the panel — and those are very different prices. What we’re looking for in your photos is the path, not just the endpoints.
If the charger itself needs to live outside, on a carport or beside a driveway, that’s no problem either. We run weatherproof conduit on every install regardless of where it goes, so outdoors isn’t a compromise — it’s the same standard.
Which charger should I get — J1772 or NACS?
This is worth getting right, because the goal is that charging at home takes one hand and no extra pieces. Nobody wants to keep track of an adapter in their own garage.
There are two connectors in use: J1772 and Tesla’s NACS. Which one you want depends on what you drive, and it’s the first thing we’ll confirm with you. Some units — including Tesla’s universal wall connector — carry both, which is the safe choice if there are two different cars in the household or you’re not sure what you’ll be driving in five years.
We’re certified for Tesla and ChargePoint and we install every other major brand. Already bought one? We’ll install it. Haven’t? Tell us what you drive and we’ll tell you what we’d put on our own house.
Still unsure whether your setup works? That’s exactly what the photos are for — send them and we’ll tell you straight.
Get my same-day quoteWherever your car parks
Panel on the wrong side of the house, no wall to mount on, a detached shop, two cars to charge — we’ve wired all of it. Every photo below is our own crew’s work around Austin.
-
Two cars, one wall Twin chargers, matched heights, no cable spaghetti. -
Exterior brick Mounted beside the garage door, weatherproof throughout. -
Not just Teslas Mercedes, BMW, Rivian, Ford — every major brand. -
No wall to mount on Pedestal set on a poured pad, right where the car sits. -
Detached building Subpanel and charger at a shop, well away from the house. -
The tricky run Conduit up and over the garage door to reach the far wall.
Not sure which one your place looks like? Send photos and we’ll tell you.
How we do every install
Most of this you’d never see until install day, so here’s what you get from us on every job.
|
|
|
|---|---|
| Getting a price | Photos in, a real number back the same day |
| Who’s in your house | Our own electricians on every wire run |
| The wire in your wall | Heavy-duty on every install — your next car won’t need a rewire |
| Charging speed | 48 amps wherever your panel allows it |
| Outdoor runs | Weatherproof conduit as standard, inside or out |
| If your panel isn’t safe | We tell you, even when it costs us the job |
| Permit and inspection | We pull it, meet the inspector, and guarantee the pass |
Questions about any of these? Ask us, we’re happy to walk you through it.
Get your Austin quote today
Two minutes on the form, a few photos from your garage, and a real number back the same day. No site visit, no salesperson, no surprise on install day.
Get my same-day quoteQuestions first? Email info@chargeprotexas.com
We also install home batteries, generators and panel upgrades, and handle general electrical work. Mention it in the form and we’ll quote it together.
Charge Pro Texas · Licensed electrical contractor · TECL #37972
